How to Flash Your Eurovox, Eurovox Flashing Guide.

How to put the firmw@re onto your box.


1. Connect your Eurov0x unit to your PC using the Null modem serial cable as shown above in the other post.

2. Plug in the power cord on the Eurov0x unit and wait until (----) appears on the front display. If it has been flashed before you will see 4 digits instead, leave your Eurov0x on standby.

3. On your PC/Laptop Run the UFL Eurovox program which you downloaded in the post above.



3a (Optional recommended step to save you time) Press the Upload button to save your channel set up favorites etc as they currently are, Save this to a folder on your PC for use later.

4.Click on the 'download' button then wait until you see the following and click start.



If you do not see this – check your connections between pc & Eurov0x, also if you get the message system reset, turn your box off at the mains, hit the download button then plug your box in, (this may require a few attemps).

5. Now download will start and you will see the following,



Eurov0x unit will now show dnld flashing on the front display.

6. After the above window – the following will display



7, When all is finished the following will display,



Now your box is done,

If you did the optional step at 3a, then using the UFL click browse to where you saved your file (CDF file) and click download in the lower box on the Kuro program, and it will reload your favorites etc as you originally had them, if you didn't save your CDF you will have to rescan your box using the powerscan method which is explained below

No firmware is to be hosted on TechKings.

Flashing The EX7000HD using USB

1. Download the required firmware
2. Unzip and copy it to your usb pen or equivalent, ensure filename is (flash.tbn).
3. Insert it into the usb slot and switch power off then back on at the rear switch.
3. box will reboot, open the flash file extract it to its memory and install it automatically.
4. Once flashed its a peice of cake select your desired settings, scan then enjoy.

Hi

i have downloaded the firmware but the box is saying updating code when i look for channels. Does this always happen or haVE I DOWNLOADED THE WRONG FIRMWARE

Have you left it on a channel long enough to update. What box and what does it say in system info?.

Hi there hiteck a big ty 4 this gr8 guide. i have just ordered a eurovox ex1000sl box. Im wondering if i need 2 flash the firmware with new firmware, or do i just follow the installation guide.


I am a virgin media customer so could u plz send me the values. Many thanx draxs76 aka chris

Hi Chris, your welcome mate,

You will probably need to flash it mate as the majority come with the free to air firmware installed. The firmware links are in the other stickies in the eurovox section, may I ask where you bought it?.

i have downloaded the firmware a big thanxs. i bought the euovox from a website called *edited*. It comes with the rs232 cable aswell free of charge.

I wanted to know to rule out it being a clone but you will be fine as you bought it from a reputable place. Yes download the firmware and follow the guide above, if you have any problems just let us know.

on ur table guides after u have flashed the firmware, which table guide do i use for virgin media plz.

Your in Doncaster on telewest so use 6952 as your symbol rate, start at 100.00 end 850.00, step set to 8.

wow how do u know im fron donny. do i have to subscribe to virgin to get there cable feed. Im asking because all i have is there broadband at t mo. When there engineer came he said i had to much juice coming down my line and he had to put a supressor into the back of my modem. its a 10db attunator.