eurovox ex5000pvr

i am using the eurovox ex5000pvr and when i did a scan i lost alot of my channels and not got a clue on how to get them back and i have tryed to rescan and no luck with it

Originally Posted by daz170981

i am using the eurovox ex5000pvr and when i did a scan i lost alot of my channels and not got a clue on how to get them back and i have tryed to rescan and no luck with it

i've had this before start but powering the box off then fire it back in again and do a deep scan

Might be worth checking the N3 regions list to check firstly your area has not received new cards there is a thread for this in here. If your area is still ok try a factory default settings then a deep scan, they say it is best to do this either very late at night or very early morning to get better signal strength.

Need abit more information daz to get anywhere near helping you.

Which area are you from?

Be careful using factory settings , as i have found that this can actualy wipe most if not all of your cannels, resulting in having to re'flash the box.

Originally Posted by jonter36

Be careful using factory settings , as i have found that this can actualy wipe most if not all of your cannels, resulting in having to re'flash the box.

The factory default reset is there to put the Eurovox to factory default state. It will not do anything to the firmware itself so there is no need for reflashing the box after doing a factory default reset. It will simply wipe your box and you just have to scan for the channels again.