H.2S fails to boot (W7) after s/w updates on 24/11/17

kwick1 · Nov 24, 2017

Hi,
I upgraded to Wooshbuild 7 two days ago and all has been ok however, this morning I applied 11 updates from the s/w update page and the box fails to boot. It is stuck on the boot with red light even after power off/on
Any suggestions before I attempt to re-flash?
regards,
Kevin

grog68 · Nov 24, 2017

it seems to happening on atv 6.1 over past few days even though the status icon is green. I've had half a dozen people contact me saying they've done the software update and it now doesn't boot and I tried this morning to do software update and the same thing happened. I think a reflash is the only way to fix. Probably the quickest as well:)

wooshman · Nov 24, 2017

nocluescot said:
wish i came across this post before i tried WB7 update, stuck on boot.
re-flashed and back up and going, will not be updating for a while.

Updating to WB 7 doesn't cause the box to get stuck. Running software updates on an OpenATV 6.1 image does.

Three times today is has been posted in the WB thread not to run software updates.
http://www.techkings.org/threads/wooshbuild-support-thread.109525/page-131#post-820164

wheelo · Nov 25, 2017

There is a dedicated wooshbuild thread, if its a WB problem, post in there, helps everyone who has the same problem.

JideJames · Nov 25, 2017

wheelo said:
There is a dedicated wooshbuild thread, if its a WB problem, post in there, helps everyone who has the same problem.

I don't know where to get help.
Can redirect me to the right forum, please?

Ad29434 · Nov 25, 2017

JideJames said:
I don't know where to get help.
Can redirect me to the right forum, please?

Wooshbuild Support Thread

Search

Search

H.2S fails to boot (W7) after s/w updates on 24/11/17

kwick1

Newbie

grog68

VIP Member

wooshman

VIP Member

wheelo

Admin

JideJames

Member

Ad29434

Member