oscam

Short Glitches fairly often. 3 or 4 mins I have noticed Oscam is popular I use Cccam. I have 4 clines I may try another server is also a possibility. Not sure of my problem. Router Hard wired to Zgemma H2s. 34Mbps Is Oscam a better option? thanks.

Hi All Im in need of some desperate help, I'm a newbie - have done a lot of reading to try and sort this on my own but have now admitted defeat and hit a brick wall. I have a N/CWS line for VM and have a VU+ Uno 4K SE box running the latest version of Vix. I have installed OSCAM and converted...

Anyone else experiencing a little bit of freeze on ITV 1 HD ?

Hi, I previously had this issue with running n-lines, however I changed to cws - lines and had no issues until today. Before when I was running N-Lines via the newcamd protocol on Oscam viewing was okay but recording programmes sent the log in a spiral of "not found"s' That's when I tried...

VU+Uno4k - OSCam Anyone got this working well ? I can watch Live Tv via the box or a 2nd device. But when I record everything goes wrong... The recordings freeze, live tv fails to decrypt every so 30/40seconds. I have 4 proxies connecting to 2 different servers. I know it's an OSCam issue...

I'm quite new to this, and this is probably a much discussed issue, but after much searching and trying I cannot find a way to run a newcamd file content on the H7C. I have tried converters, tried copying and pasting the information into the oscam file, but nothing works. Am I wasting my time or...

I am just wondering if my settings for OSCAM are good? I know in mgcamd you have keepalive but I have only ever seen it used in oscam with cccam perhaps someone can help. Mostly concerned with conf and reader. are there excess things in there that i don't need or might only be required for a...

Hi everyone, been having a few problems with my uno 4K. I get glitches every few minutes. It's flashed with openvix and just updated my oscam to the latest one. I no it's been discussed a few time and I'm 90% sure my config files are right and the line is ok. I was reading a post about it...

Hi Guys Anyone with a Technomate Twin4K find that its extremely hot to touch? I took its temperature with a baby's thermometer. It read over 90 degrees on the top side. The bottom feels even hotter!! This cannot e normal or is it? Its brand new and cane with a HD fitted by W.O.S. See attached...

Hey all, I have a new box (Mutant HD51) and I need help setting up OScam as this box only supports this cam. Could someone help me with what files I need to load onto t

Config file for Oscam Port :8888 Can be used for ATV if you have issues with the standard Oscam downloaded from plugins. There is a blank reader for cable and one for satellite, just edit what you need and switch off the second reader if your not using two readers. Pm me for any help :)

hi guys, want to upgrade my current box ( Zgemma star H1 ) running openvix as this doesn't allow me to record & watch 2 seperate channels , i can only record the channel i'm watching , i am on VM Cable , i only have one feed no Sat in the house so i'm looking for advice on what to get , so...

Installing the softcam menu FTP to temp folder, then install local extension Menu>setup>software management>install local extension>Memory/temp>the file your trying to install should be there, make sure you tick the box and install it.

Setup guide for Open ATV, cable setup. All the information you require should be in the guide if there's anything your unsure about, post in the thread below and someone will kindly answer. Whilst setting up, if it’s mentioned to reboot/restart your receiver then do this by using your remote...