1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

PUTTY but no OPENWEBIF

Discussion in 'Zgemma-Star H.2S' started by Fattony, Dec 9, 2016.

  1. Fattony

    Fattony Registered

    58
    1
    Hi,

    Most probably being stupid, but I can TELNET with PUTTY into my box, but can't open OPENWEBIF in a browser.

    Any suggestions would be helpful.

    And thanks in advance.

    Cheers
     
  2. dsayers2014

    dsayers2014 TK Veteran

    9,791
    1,196
    image? openvix have changed how openwebif works you now need to install it rather than it being on by default
     
  3. Fattony

    Fattony Registered

    58
    1
    Using Wooshbuild, would I be better removing Openwebif and then reinstalling?

    Cheers
     
  4. dsayers2014

    dsayers2014 TK Veteran

    9,791
    1,196
    No should be fine on wooshbuild.
    Are you sure the ip address is correct

    Sent from my SM-G925F using Tapatalk
     
  5. Fattony

    Fattony Registered

    58
    1
    I can access via Putty so it should not be different


    Sent from my iPad using Tapatalk
     
  6. grog68

    grog68 TK Veteran Forum Supporter

    3,053
    1,113
    what do you see if you access the box ip in a browser?
     
  7. Fattony

    Fattony Registered

    58
    1
    Blank page only say refused access


    Sent from my iPad using Tapatalk
     
  8. grog68

    grog68 TK Veteran Forum Supporter

    3,053
    1,113
    Press the green button on your remote and select OpenWebif.

    Make sure its enabled and on port 00080