How to take apart the xbox 360

**homesick** · 28-04-2009, 06:15 PM

This is a YouTube video that shows you step-by-step how to disassemble an Xbox 360. One of the best tutorials out there. This video is mine.

[VV]4559826[/VV]

**axxxo** · 29-04-2009, 11:22 PM

good video, better than the one i was watching from youtube, i have to open mine again as the eject button wont work anymore, its ok for now i just have to leave the faceplate off to stick somthing small in to open it but its a pain in the backside opening it and putting it back together again, hope i didint break the button, sure a new case can always be purchased!

**7thsinger** · 29-04-2009, 11:36 PM

Thread stickied.

**homesick** · 30-04-2009, 12:08 AM

Originally Posted by axxxo

good video, better than the one i was watching from youtube, i have to open mine again as the eject button wont work anymore, its ok for now i just have to leave the faceplate off to stick somthing small in to open it but its a pain in the backside opening it and putting it back together again, hope i didint break the button, sure a new case can always be purchased!

sometimes the screws wont go back in right and you can force them, and think everything is ok, but when you put the eject button back on that 1 cm difference will make it not work, just take the case back apart and re-seat it and it should go back to functioning properly again.

**axxxo** · 04-05-2009, 07:44 PM

i just have the faceplate off for now, definately out a fraction is all, too lazy too take it apart again. ill do it again when its needed (around the middle of may i think

)

**homesick** · 04-05-2009, 10:55 PM

Originally Posted by axxxo

i just have the faceplate off for now, definately out a fraction is all, too lazy too take it apart again. ill do it again when its needed (around the middle of may i think

)

, glad you figured it out!

**HiTeck** · 09-05-2009, 07:36 PM

Added a Vimeo bbcode HS so you can play the video here as discussed earlier you will see when posting a

button.

Just press that when posting and copy the numbers at the end of the share link eg,

http://www.vimeo.com/4559826

HTML Code:

[VV]4559826[/VV]

I cant make it play in the video directory as it only works for youtube "for now

"

Please everyone, dont forget to show your appreciation for the amount of time and effort homesick has put into this by pressing the "thanks" button under his Tutorial.