What's new
By:
Filters

WilloBuild WilloBuild OpenViX 6.5 Series

Hi. Guys,
I have latest willowbuild, on Zgemma H7s and SlyQ-1080 skin, I use just free to air

Ive noticed Picon Not appearing in info bar on any programs please see and expand picture attached, picons appear OK in epg but not in info bar, please could someone guide me on how to do this, I've had a good look about but can't see where I am going wrong
 

Attachments

  • 20220401_133610.jpg
    20220401_133610.jpg
    1.5 MB · Views: 12
Last edited:
Fine here. Have you actually downloaded the SkyQ picons?
If not use dsayers picon updater in the plugin menu.

1648824767773.png
 
Thanks, apologies for having 2 posts going, i didn't seem to get a response from this post so thought it may have been in wrong place.

Anyway, yes I had already used Dsayers plugin and downloaded both picon files, and for good measure just done it again now, and it makes no difference I'm afraid.
 
I installed the Image on Octagon sf8008 but couldn't connect VUCC or Total Commander. Checked many times my network connection/password and am 100% sure they're ok. On other images using same network/password connection works fine. What could be the problem. I will have to re-flash because I had to delete the Image. Thks.
 
Checked samba which is running, did a network test and all ok but still no connection.
Edit I re-installed, rebooted and restarted from mains and connection is now working as it should. Many thanks.
 
Last edited:
coozer said:
no, just followed willos instructions.. whats does that do?
Click to expand...
It clearly states on Willobuild installation instructions:

YOUR BOX MUST HAVE A NETWORK CONNECTION AND YOUR STORAGE DRIVE MUST BE PLUGGED IN AND MOUNTED AS /MEDIA/HDD. (PREFERABLY FORMATTED AS EXT4).​

 
You must log in or register to reply here.
Back
Top