Wooshbuild says no cam in sofcam panel so channels not working

mcg1987

Newbie
One of the boxes I have setup back at home - 500 miles away - has stopped working in the last hour so I'm getting asked how to fix it from here.

Usually i'd just reflash the box but obviously can't do that from where I am.

Was working fine but now It says "no cam" in softcam panel and it can't be started using the green button. I've got all the connections checked and all are OK and I've connected to the box via teamviewer and tried to ftp over the line again but it won't start.

Says "no cam started !! Cam 1 must be different from Cam 2"

Now I can't say for sure if anyone was arsing around with it but i'd assume so even if only by accident.

Any help much appreciated to save me a headache lol
 
When cam1 is highlighted use the left/right arrow keys to select Ccam or MGCamd then press ok and see how you go from there!
 
When cam1 is highlighted use the left/right arrow keys to select Ccam or MGCamd then press ok and see how you go from there!

Aw here I found that out then after reading through pages and pages on here but thanks for the reply! But I'd already gone and downloaded all the relevant files etc. again and reinstalled them but this would have worked too!

They had DEFINITELY been arsing around with the box and just wasted 90 minutes of my work day! Thanks again all sorted!
 
I've had that happen on two boxes (one of them mine) and I definitely hadn't been messing with it. I don't think the other person would have fiddled with it either. Happened over consecutive days.
 
One of the boxes I have setup back at home - 500 miles away - has stopped working in the last hour so I'm getting asked how to fix it from here.

Usually i'd just reflash the box but obviously can't do that from where I am.

Was working fine but now It says "no cam" in softcam panel and it can't be started using the green button. I've got all the connections checked and all are OK and I've connected to the box via teamviewer and tried to ftp over the line again but it won't start.

Says "no cam started !! Cam 1 must be different from Cam 2"

Now I can't say for sure if anyone was arsing around with it but i'd assume so even if only by accident.

Any help much appreciated to save me a headache lol
Hi mate, how did you solved this out, am having the same issue with my zgemma box, just purchase and have follow the same installation process and after putting the c line through FileZilla and going on softcam panel V2.0 am seeing No cam started!! cam 1 must be different from cam 2
 
when you go to softcam panel, highlight active cam 1
then scroll left/right until CCcam2.3.0 appears
then press the green button to restart the cam, this will load the line and clear the channels
 
Back
Top