What's new
By:
Filters

Cant flash zgemma h9s

R

reevey

Newbie
hi I Cant reflash zgemma h9s
I have the orignile working usb but have tried other usbs just incase I flashed a few different images. but turned box on today as wanted to put wooshbuild on and it wont let me flash a new image. I have tried loades of new images but will not flash. when I go into OpenWebif terminal does not show up and I cannot connect with putty box say network is on.
do you think it could be a bootloader issue if so where would I get one. any help and info greatly received
thanks steve
 
So it doesn't respond to any remote key presses and you can't access via Putty?
Format your usb stick using this and flash by usb. I think you may have to hold the little button in when you power on.
 
  1. Use FAT32 formatted USB stick
  2. Send the h9 folder and 2 files (“bootargs.bin” and “fastboot.bin”) to the clean USB memory stick and then take it out of your PC properly expelled first
  3. Switch off your Zgemma H9 at the back, using the white power button
  4. Insert the USB stick into the back USB port of your H9
  5. Press and hold the small, black RESET button at the back, then
  6. Press the white POWER button, while holding the RESET button
  7. Let go of the RESET button once you see the LED flashing (changing colour between white and red)
  8. Wait for the box to load after the installation.
 
You must log in or register to reply here.
Back
Top