Configured Sat's not available when in Manual and Blind Scan mode.

norb

Newbie
Hi
Platform is a ZGemma H9S
Just re-testing OpenVix -5.3.006, setup tuner in A/B/C/D mode with 13.0, 19.2 and 28.2E.
All good with this but when trying to perform either a Blind or Manual Scan I get presented with Sat's on 4.8 and 9.0E which are not even configured at all.
Where can I look to find out what is causing this?
I have done this before with other images where I remember at least under OpenATV, I could do a manual scan on any of the configured satellites configured in the Tuner.
No matter whether I set the Type of Scan to Single Satellite or any other settings only those 2 Sat's are offered without being able to use my won ones.

Tuner Setuo.jpg
Manual Scan.jpg
Multisat.jpg
 
Back
Top