Hi
I have recently purchased this box and have it set up with W/build latest version
The big problem I have is motorised settings.and scanning.
I would be grateful if someone could run through with me the correct settings and procedure.I have TUNER A ,set on simple single sat 28 degrees and a scan worked fine.However there are so many other options e.g.simple advanced-postioner/USALS select.
When I have moved the dish,nothing scans on other sats .
When I had a Spiderbox,it just moved dish and scanned,this seems a whole lot more problematic.
I have C lines for foreign sats,so want to use box for both cable (not set up yet) and sat.
If someone could go through what should be put in and the procedure,this would be much apprecaited
I have recently purchased this box and have it set up with W/build latest version
The big problem I have is motorised settings.and scanning.
I would be grateful if someone could run through with me the correct settings and procedure.I have TUNER A ,set on simple single sat 28 degrees and a scan worked fine.However there are so many other options e.g.simple advanced-postioner/USALS select.
When I have moved the dish,nothing scans on other sats .
When I had a Spiderbox,it just moved dish and scanned,this seems a whole lot more problematic.
I have C lines for foreign sats,so want to use box for both cable (not set up yet) and sat.
If someone could go through what should be put in and the procedure,this would be much apprecaited