WooshBuild H7C setup

I have a h7c on order. I was advised on this forum to flash with VIX. Zgemma tell me it is coming with openATV, so
I thought, load WooshBuild. I can’t find any info on how WB configures T2 tuners for Freeview. Do I just need my
transmitter name?
GOP
 

Willo3092

VIP Member
TK Supporter
The H7 comes with 4 partitions and you can flash a different OS / build to each one without affecting the original which would be on partition 1.
Try a few different images and then use the one you like best.
 

Goodolpete

Newbie
Thread starter
Thanks, didn’t know that. If I flash VIX next, having set up the tuners in OpenATV, does it remember the config?
 

Jimdefruit

Newbie
Once you get the settings and bouquets the way you want them on one of the four images, copy them to your PC using DreamBoxEdit and then you can load them back to other images again using DreamBoxEdit. Saves a lot of time.
 

Goodolpete

Newbie
Thread starter
Once you get the settings and bouquets the way you want them on one of the four images, copy them to your PC using DreamBoxEdit and then you can load them back to other images again using DreamBoxEdit. Saves a lot of time.
I’ll look into that. Thanks.
 

Goodolpete

Newbie
Thread starter
If I take my recordings off my Topfield PVR ( *.TS files) and ftp them to the zgemma, can I play them?
 

Jimdefruit

Newbie
Put a folder mpg on your Zgemma hard drive and ftp movie files to that folder. Some images will play .ts files but some don't. Mediaplayer will play most movie files.
 
Top