Locksnapper
Newbie
so been running Wooshbuild with Enigma2 for Iptv since April with no issues. The other day I put in deep standby and unplugged the box. A couple of days later I powered up to watch the footy, and the box would not boot properly, first of all pausing at 49, then at 80 (when the display would dim??)
Reflashed woosh, it did the same, Wooshbuild would display on the tv until it pausing at 80 (the tv would then show no signal) and lcd dimming, but eventually continued to complete and show the clock with green light. However when I press FAV, nothing happened. So tried rebooting a few times with no joy. By accident I pressed the red power button once booted, and it put the box in standby, when pressing power again it came to life.
I inserted my details, and I received my channels, but with no sound.
I then followed some advice from wooshman and tried to reset my firmware with open atv. It’s now just paused on 49. Some prompts came on the screen re HDMI, but the flicked off.
I can post some pics if it helps.
Any suggestions?
Reflashed woosh, it did the same, Wooshbuild would display on the tv until it pausing at 80 (the tv would then show no signal) and lcd dimming, but eventually continued to complete and show the clock with green light. However when I press FAV, nothing happened. So tried rebooting a few times with no joy. By accident I pressed the red power button once booted, and it put the box in standby, when pressing power again it came to life.
I inserted my details, and I received my channels, but with no sound.
I then followed some advice from wooshman and tried to reset my firmware with open atv. It’s now just paused on 49. Some prompts came on the screen re HDMI, but the flicked off.
I can post some pics if it helps.
Any suggestions?