Help with MAG 322

[tmc007]

Hi looking for help with this unlock screen

 

[bazcfc1]

Try 0000 did you buy it brand new or off some one

 

[TheMacMan]

As baz said also once you are in you can disable the password in settings

 

[tmc007]

Have multiple of these if you know what i mean was sent back to me have tried to flash it with usb but disnt seem to work

 

[tmc007]

Have tried 0000 aswell dost work

 

[TheMacMan]

Have you tried to do a box reset. Ie is there a reset pin hole.

 

[bazcfc1]

Have you tried 1234 or as mentioned is there a little reset hole on the box

 

[tmc007]

Ya tried the reset but still ends up at the above screen its

 

[tmc007]

Ya tried 1234

 

[tmc007]

It's must be a pw added by someone that has forgotten it

 

[tmc007]

Done abit more looking on the net and found this might help someone in the future

 

[tmc007]

Hello



Hope this helps someone with the same problem I had. With the help of Informir's guidance this is what i had to do to get rid of

the unlock password I was getting at boot up. (I didn't set a password to begin with). Tried to factory reset from the system utility menu. Also tried to do a firmware update, nothing helped. Tried using all password found on the web e.g. 1111 0000 9875 7274 etc.



Pressing the reset button at the back of the mag 322w1 device will get you into 3 mode types as follows.



mode 1 = slow blinking of the front led

mode 2 = fast blinking of the front led

mode 3 = continuous led on



They told me to get into mode 2 which is fast blinking. I had to press the reset button till the led cycles from mode 1 to 2 then release it when its in mode 2. The device will do a factory reset then restart.

Finally the mag322 booted up to factory setting without the unlock password.



Could not find this information any where on the web.

Thanks again Infomir for your kind and prompt support.



Glenn

 

[TheMacMan]

 

[mondouble]

those info you can find in the wiki infomir ...and more