What's new
By:

Hotbird 13.0E ZGemma H2H WooshBuild

A

Ardat95

Member
I have Virmin set up with WooshBuild but I would like to use the Sat Tuner for 13.0E. I can't seem to get signal for any HotBird Transponder. Its for my mum as she watches some African Channels. I do not need 28.2 E on the Sat Tuner. Any advice on what to do. Thanks

Sent from my A0001 using Tapatalk
 
Would I need to? I have two separate dishes. One was a Sly Dish and the other is a Hotbird dish coming through one LNB Cable.

Sent from my A0001 using Tapatalk
 
Another case of not giving all the revelant info in the opening post...

If the satellite you have that is fixed on hotbird is still accurately aligned, you can screw this into the lnb feed in the box and setup the tuner in tuner config then enable hotbird in the providers section in ABM.
 
If both dishes are coming in via one cable then there must be a diseqc switch somewhere,?
Have you turned on diseqc on the box,?
 
For Tuner Configuration, what mode do I use? And do I say Yes/No to the messages Set Voltage and 22KHz and Send DiSEqC only on satellite change

Sent from my A0001 using Tapatalk
 
Yes, for the openboxes all I did was one plug and would receive both satellites

Sent from my A0001 using Tapatalk
 
I don't know if your box is the same,
I have an edision,
Diseqc turned on,
Port 1 = 28e Port 2= 19e and Port 3= 13e
Obviously you need to know what port is what satellite on your setup,
 
UPDATE: I have received only 300 13.0E Channels, some TPs coming with no signal

Sent from my A0001 using Tapatalk
 
Any reason as to why I only receive ~40% SNR for mainly Vertical Transponders?

Sent from my A0001 using Tapatalk
 
Ardat95 said:
Any reason as to why I only receive ~40% SNR for mainly Vertical Transponders?

Sent from my A0001 using Tapatalk
Click to expand...
It could be a number of things, bad connections, Diseqc switch, bad LNB or LNB off Skew, (the 2 most likely causes for this),
how long since you last used the 13E dish, & did it work alright before.
you started by saying it's for a ZGemma H2H, then you mention it's for openboxes, I have a channel list for the V8s Here if it helps.
 
mike142 said:
It could be a number of things, bad connections, Diseqc switch, bad LNB, LNB off Skew, (most likely cause for this),
how long since you last used the 13E dish, & did it work alright before.
you started by saying it's for a ZGemma H2H, then you mention it's for openboxes, I have a channel list for the V8s Here if it helps.
Click to expand...
I lasted used the LNB yday and it worked perfectly. I haven't had any issues. Just to mention I get signal for all TPs for 28.2E but very few TPs work for 13.0E

Sent from my A0001 using Tapatalk
 
You must log in or register to reply here.
Back
Top