IFD Protocol Source

paulowen1967

Registered
HI all. I have got a new Zgemma H5 with Wooshbuild Infinity on (Virgin). When i go into IPTV (E2i player) i can go into the various sections to find programmes but when i try to play i get the information message "! IFD Protocol Source" and it wont play. All the main channels IE, movies & sports are working ok.

I have exactly the same software on a Zgemma H2H and E2i works ok on that.
 

grog68

TK Veteran
Forum Supporter
basically the developer of E2iplayer stopped updating it some time ago, someone else has taken it on and carried on its development as E2Istream
 

paulowen1967

Registered
I have downloaded the installer sh file to my desktop. Do I drag it into the bin file ? (bin/sh)
 

grog68

TK Veteran
Forum Supporter
read the post I linked to above. enter the relevant command directly on the box
 

paulowen1967

Registered
read the post I linked to above. enter the relevant command directly on the box
Thanks for your info. Unfortunately still not working. When I did what is said the box eventually went into reboot and froze. Tried everything but eventually had to re-flash.
 

paulowen1967

Registered
basically the developer of E2iplayer stopped updating it some time ago, someone else has taken it on and carried on its development as E2Istream
Hi. I have installed E2i stream now, and it still comes up with 'Information IFD protocol source' and will not load
 

grog68

TK Veteran
Forum Supporter
what version of ATV are you running ? Menu -> Information -> About then version number about half way down
 

samsid

Registered
Hi. I have installed E2i stream now, and it still comes up with 'Information IFD protocol source' and will not load
go to e2istream fb page ,closed group, join, then go to announcements page, there are 2 tuts & commands for instal of PyCurl & updating FFMpeg , try the 2nd (FFMpeg)one it should sort your issue
 

mattchin16

Registered
No not had a chance too have another look yet.. will that be in the plug-ins. Thanks
 

Sirius

Forum Supporter
go to e2istream fb page ,closed group, join, then go to announcements page, there are 2 tuts & commands for instal of PyCurl & updating FFMpeg , try the 2nd (FFMpeg)one it should sort your issue
Hi how do I find this page, where do I look thanks
 

bk81

Registered
go to e2istream fb page ,closed group, join, then go to announcements page, there are 2 tuts & commands for instal of PyCurl & updating FFMpeg , try the 2nd (FFMpeg)one it should sort your issue
it works ive done it this morning
 
Top