Kelhaggagi
Newbie
at the title says, what should I make with my 3d printer? I had it for about 6 months and used it for bits of fun (making chess sets, the Mandalorian etc) now I want to get into it a bit more.
Thanks
Thanks
I've started using my 3d printer more recently ... what should I make?
- Thread starter Kelhaggagi
- Start date
Kelhaggagi
Newbie
do you have an image of one so I can have a better idea of what you are after?
Kelhaggagi
Newbie
I found this DJi Mavic Pro Big parts set :-) by mnis anything on the list I can print if it helps
Unfortunately the items listed are for mavic / not 2 pro.
Thank you for trying really appreciated.
Kelhaggagi
Newbie
Unfortunately for something like this as I don't have a dji mavic 2 pro I can't design the protector but if you can find an *.stl file for one I can print it for you
I was tempted to buy a 3d printer, using Gingiverse as a beginners guide.
Yes mate it the bottom piece
Protects the underside sensor in transit
Like this boss? DJI Mavic Pro_Propeller Lock v1 by Deboize
That would stop my downward sensors getting prop burn ..can I choose a colour. Lol
Kelhaggagi
Newbie
What colour i have a few
Grey or black would look great... not sure whether @wheelo is helping out. Apologies to either of you..
Kelhaggagi
Newbie
I need to get my son to bed as he has woken up. I can always order a colour
Kelhaggagi
Newbie
I have black. I will check tomorrow if thats ok to make sure the file is ok
Top man @Kelhaggagi I love the way this place is so friendly and helpful.
Kelhaggagi
Newbie
Morning, the files were a little wooly (needed to be modded a bit - upscaled by about 2600% based on others who have used it) but apart from that seem to be ok. There are two parts and each part will only take a couple of hours to print so not bad. I assume you are in the UK for postage