Mag 349 blocked

John Dough

Registered
Just got genuine magbox but when I put in portal it says STB is blocked.
Software is Aug 2018 and embedded portal works fine.
The supplier says there is new Linux software for servers so would that be the problem? My iptv guy says all his magbox clients are working ok.
Is there 2 Mac addresses for wi fi boxes like mine.
Tnx.
 
Sponsored Links

Nepose

Registered
Hello friend :)
Check with STBEmu if connect does okay. Try it with presetting MAC address from sticker at STB's bottom.
Also do you use public or factory software? If you can please provide output from ifconfig on STB using SSH. Default credentials are user root, passwd 930920 and port 22.
 

John Dough

Registered
Hello friend :)
Check with STBEmu if connect does okay. Try it with presetting MAC address from sticker at STB's bottom.
Also do you use public or factory software? If you can please provide output from ifconfig on STB using SSH. Default credentials are user root, passwd 930920 and port 22.
Not sure how to get STBEmu on box??
Using factory software.Tnx
 

formandvoid

TK Veteran
Forum Supporter
I thought stbemu was for android,not mag box . Never had any problems with mag boxes but never used a 349 tbh.You Just give the supplier the mac from the bottom of your box and enter his portal and that should be it. Never heard about new Linnux software unless your box is not supported.Maybe someone else can comment.Do you have any family filters enabled by your internet provider that could be blocking you.
 

Zegmmakhan

Registered
Operating system - Linux 3.3 thats installed on most if not all mag boxes...
https://www.infomir.eu/eng/products/premium/mag349/

ask him to chk if your box is supported on his server...
I had the same problem. Its because of the new 349 box . Most of the server would not support it. Some of the severs would support it but not fully. Box would get stuck etc. I have the box supplier and the servers aswell both are saying thats compatibility issue of the two.
 

Nepose

Registered
Not sure how to get STBEmu on box??
Using factory software.Tnx
Does your provider use Ministra? Infomir declares supporting 349 at ministra but... ;) About mac addresses, install public soft and connect to stb through ssh protocol. Do ifconfig
 

John Dough

Registered
I had the same problem. Its because of the new 349 box . Most of the server would not support it. Some of the severs would support it but not fully. Box would get stuck etc. I have the box supplier and the servers aswell both are saying thats compatibility issue of the two.
Infomir dealer says new Middleware needed on server and my provider seems like he installed it and all working now apart from recording and downloads to USB so certainly a improvement.
This box is much faster chip then 256 and no buffering so far.
Only problem is it locks up on providers settings panel for some reason.
 
Last edited:
Top