WooshBuild No stations

NeVeR

Member
I gave my parents my zgemma S2 box. I connected there sat cables and there's no stations.

I tried to rescan but says 0 channels found.

Could the dish be out of alignment? I don't live here so not sure if it moved with the weather etc.

They told me it was working before.. but they don't know when it stopped working ( there old box I mean ) I thought there old box gave up.. so thought replacing it would work.

I can't get to the sat dish.. is there anything I could check to see if it's out of alignment or something else?
 
Was there a sky q used there by any chance,different lnb in use there.
Is sat cable going into correct port on box.
Water ingress of cables or dish moved also a possible.
 
Was there a sky q used there by any chance,different lnb in use there.
Is sat cable going into correct port on box.
Water ingress of cables or dish moved also a possible.
No they never had Sky. Sat dish was installed by a company offering FTA stations.. and it worked for a long time

I've checked cables are connected to right port.. even changed them about just incase.
 
So possibility is it could have moved or lnb fault=no signal as i have that and have to get lnb replaced .Other feeds work on the same dish.
Any other feeds in other rooms to check?
Sometimes installers dont tighten f connectors when fitting to lnb and leave skirt up.
 
What settings are you putting in for the scan

What’s the tuner layout on it. Single or double? Does it have a output, easy to set it up wrong
 
Back
Top