assassin84
Newbie
I am using through Vermin cable, with no connection problems and good internet speed through LAN. All channels are showing on a complete manual scan, with around 70% signal strength, but just a blank screen for anything that isnt FTA. I usually do manual > complete scan on tuner B if any issues occur, but this isnt working.
Bit of a noob over all this, as it was sent already pre-configured. Everything was fine until the power was completely shut down at my house last week, since then only FTA. Tried a few fixes but none seem to work. Anyone else had a power down and then issue with channels after it?
If any other info is needed im happy to add. Any help would be great thanks.
Tuner A: BCM7346
SAT: 28.2E ASTRA 2E/2F/2G
TUNE: Predefined
Transponder: 10714 H 22000 5/6
Signal all 0% for A
Tuner B: CXD2837 (DVB-C)
TUNE: Predefined
Transponder: 115 MHZ 3/4 6952 256-QAM
Picking up close to 500 on auto bouquets too.
Bit of a noob over all this, as it was sent already pre-configured. Everything was fine until the power was completely shut down at my house last week, since then only FTA. Tried a few fixes but none seem to work. Anyone else had a power down and then issue with channels after it?
If any other info is needed im happy to add. Any help would be great thanks.
Tuner A: BCM7346
SAT: 28.2E ASTRA 2E/2F/2G
TUNE: Predefined
Transponder: 10714 H 22000 5/6
Signal all 0% for A
Tuner B: CXD2837 (DVB-C)
TUNE: Predefined
Transponder: 115 MHZ 3/4 6952 256-QAM
Picking up close to 500 on auto bouquets too.