Using a disecq switch with a motor and sky dish?

[waqy]

TUNER A: Motor using USALS

Tuner B: 28.2E

I have an extra 28.2E cable as well.

Could I use a diseqc switch to connect the motor and 28.2E to tuner A so I don't have to turn the dish to 28.2E if I wanted to watch another program on UK tv whilst the other tuner (TUNER B) was in use/recording something on Freesat?

 

[Ferret.]

Ive done this years back on E2 boxes with a single tuner, here are my notes from the time. The below would be using port1 AA port2 AB

Satellite--------You need this setup for each sat position but not 28e. obviously enter you coordinates.
LNB------------------------------LNB 1
Priority-------------------------Auto
LOF------------------------------Universal LNB
Voltage mode---------------------Polarization
Increased voltage----------------no
Tone mode------------------------Band
DiSEqC mode----------------------1.2
Toneburst------------------------None
Committed DiSEqC command---------AA
Fast DiSEqC----------------------no
Sequence repeat------------------no
Command order--------------------committed,toneburst
Uncommitted Diseqc Command-----None
Diseqc Repeats-------------------None
Longitude------------------------
---------------------------------West
Latitude-------------------------
---------------------------------North
Use Usals for this sat-------------Yes



Fixed dish

Configuration Mode Advanced



Satellite--------28 east
LNB------------------------------LNB 2
Priority-------------------------Auto
LOF------------------------------Universal LNB
Voltage mode---------------------Polarization
Increased voltage----------------no
Tone mode------------------------Band
DiSEqC mode----------------------1.0
Toneburst------------------------None
Committed DiSEqC command---------AB
Fast DiSEqC----------------------no
Sequence repeat------------------no
Command order--------------------committed,toneburst