WilloBuild WilloBuild OpenViX 6.4 Series

[Willo3092]

sorry mate my fault, didn't notice this was your build main thread, although you must agree ATV is far superior

 

[urie]

ignoring the newroot folder issue, the multiboot partition value error is the one that I would look at first, i've not got a multiboot box anymore so can't check but not sure why you are getting that error, you didn't enter a number, delete and then enter another number or anything did you?

no just entered 2

 

[gavinvtaylor]

Morning all I'm relatively new at flashing boxes, my question is, can Willobuild be setup on an SF8008 box and also be set for using iptv, cheers.

 

[Willo3092]

Yes it can, I build it on a SF8008

 

[gavinvtaylor]

Cheers Will, will have a good read through what you posted and attempt it later on today.

 

[Willo3092]

Just connect to the box using pUtty and login http://www.willobuild.xyz/files/Utilities/putty.zip

Enter the full line of code:

wget --no-check-certificate -O install_vix.sh http://www.willobuild.xyz/files/Scripts/install_vix.sh && bash install_vix.sh

Follow the onscreen instructions.

 

[gavinvtaylor]

 

[gavinvtaylor]

I'm getting so far and then getting that message, have you any ideas if I'm doing anything wrong?

 

[urie]

I'm getting so far and then getting that message, have you any ideas if I'm doing anything wrong?

do you have blank formatted usb in stb or initialised usb as hard drive the file needs to unpack to drive

 

[gavinvtaylor]

Sorry never done this before, so the usb dongle needs to be empty?

 

[grog68]

Sorry never done this before, so the usb dongle needs to be empty?

it needs to be inittialised on the box, not sure where to do that on vix sorry

 

[urie]

Sorry never done this before, so the usb dongle needs to be empty?

it does not need to be empty but that would be better is you system still booting at the moment ? if boot system and intitilase usb.

 

[urie]

it does not need to be empty but that would be better is you system still booting at the moment ? if boot system and intitilase usb.

Hold on I will boot into VIX and find out where to intialise.

 

[gavinvtaylor]

Yeah system still boots

 

[urie]

on VIX it is Menu\ Setup\ Storage\ Initialize Devices.

 

[urie]

Also if usb port at back you should put usb there because once intitalized you will not be removing it again unless something goes wrong .

 

[Willo3092]

 

[urie]

I actually installed willobuild yesterday to test something out on VIX on zgemma h9 combo I installed to second partition all went well flashed ok but at the end it says.

Successfully flashed rootfs! Rebooting in 3 seconds...
root@zgemmah9combo:~#

It does not reboot so you need I just entered reboot into putty rebooted machine into multiboot menu to run VIX

 

[gavinvtaylor]

on VIX it is Menu\ Setup\ Storage\ Initialize Devices.

There's menu, setup but no storage, will look at it after lunch.

 

[gavinvtaylor]

do you have blank formatted usb in stb or initialised usb as hard drive the file needs to unpack to drive

I have the flashed files on the usb for openvix that's all.