Wooshbuild install

Hi I have just installed wooshbuild to my Zgemma h.2S.
Two things I'm only getting channels 1 - 5?
the other how do I add my cam line?
I no how to use filezilla extra but I can not find the cams section on the box?
any help much appreciated
 
H.2s is for sat so assuming you have the dish connected you should be getting FTA - check the free to air category.

As for the adding the line - you can use the cam importer feature located in the WB config
 
Is it a cable box and posted in wrong section cause if you've ran a scan you should get more than 1-5
 
H.2s is for sat so assuming you have the dish connected you should be getting FTA - check the free to air category.

As for the adding the line - you can use the cam importer feature located in the WB config
Can you elaborate abit on the cam importer please do I need to add this?
 
You need to install the softcam feed 4.3 from resources section.
CCcam line goes in etc folder on new installs, CWS lines still go in usr/keys folder
 
Back
Top