What's new
By:

wooshbuild newbie

T

tritoch

Newbie
Hi all. i have a zgemma h2s.

followed instructions and put the zgemma folder and my backed up newcamd.list file onto the usb and flashed Wooshbuild.

Flashed perfectly except for nothing is working.

So i pressed blue > Softcam > Softcam Panel

and here i noticed no cams were active. so have started mgcamd_1.38r1 in cam 1 and cccam 2.3.0 in cam 2 and then restarted the box.

Still nothing... so I FTP'd to /usr/keys/ and copied my newcamd.list file there and restarted the box, and still nothing...

is there some way I can find what the problem is or does anyone have an idea? it was working fine literally before i flashed wooshbuild so I'm sure its not my N: line.
 
tritoch said:
Hi all. i have a zgemma h2s.

followed instructions and put the zgemma folder and my backed up newcamd.list file onto the usb and flashed Wooshbuild.

Flashed perfectly except for nothing is working.

So i pressed blue > Softcam > Softcam Panel

and here i noticed no cams were active. so have started mgcamd_1.38r1 in cam 1 and cccam 2.3.0 in cam 2 and then restarted the box.

Still nothing... so I FTP'd to /usr/keys/ and copied my newcamd.list file there and restarted the box, and still nothing...

is there some way I can find what the problem is or does anyone have an idea? it was working fine literally before i flashed wooshbuild so I'm sure its not my N: line.
Click to expand...

Cam 2 stays inactive, only have cam 1 active, then restart it
 
FTP the newcamd.list file onto the hdd usb.
Set cam 1 and 2 to no cam.
Leave on channel 106 and press green button/usb cam importer/ok and look to see if the info is copied over ok ?
Exit and see if it fires up.
 
OK. so i set it to CAM 1: mgcamd CAM2: no cam. restarted box - still nothing.

Then i set it to CAM 1: cccam CAM2: no cam. restarted box - still nothing.

cant figure this out :/
 
Set cam 1 to mgcam and set cam 2 to no cam. Copy the newcamd.list to a blank usb. Put usb in front slot of the box and press green then choose cam importer. Press ok and your line should copy. Oh and put channel to 106 sky before you do this.
 
benijofar said:
FTP the newcamd.list file onto the hdd usb.
Set cam 1 and 2 to no cam.
Leave on channel 106 and press green button/usb cam importer/ok and look to see if the info is copied over ok ?
Exit and see if it fires up.
Click to expand...


Wow. Didn't know you could do that. Have done it and it copied the info over correctly and suddenly all is ok!

thanks very much!
 
There are loads of shortcuts and tweaks that you will learn as you go along.
Glad this one worked and welcome to Wooshbuild.
 
You must log in or register to reply here.
Back
Top