WooshBuild Wooshbuild on Zgemma H7S -USB wont initialise

Macone157

Newbie
Hi Just starting to install and when it asks for initialise USB it gets "your receiver has encountered a software problem...check logs and then goes back to where I was at the start
ANy help appreciated please
Its a 32gb USB and I downloaded correct zip for my model from openatv
 
Skip that part and finish setting up,when done press blue button go to Hard disk and Initialisation.
I flash openatv and initialize hdd then go and flash infinity and skip hdd part as you've already done it during openatv setup.
 
Don't initialize in setup on infinity just continue with install of infinity then mount and initialise the USB once box is setup personally I would either use grog free range or willobuild with vix a lot less problems as both regularly kept updated
 
Back
Top