Zgemma H.2H stuck on standby after Factory reset

[eminem2015]

Would appreciate it if somebody could advise if this is bricked?
Lost sound so tried a factory reset and now every time I try to boot it goes through the boot sequence on the display but then stays on standby and you only see the clock. On the TV you see the OpenVix boot screen but it then goes blank.

Thanks in advance.

 

[Willo3092]

You will need to flash if you have factory reset it. You should be able to access it using putty and use @grog68 script.

Flash ATV via command line from the creators GrogBuild FreeRange - Leading the way to simplicity

Flash VIX via command line from the creators GrogBuild FreeRange - Leading the way to simplicity

 

[eminem2015]

You will need to flash if you have factory reset it. You should be able to access it using putty and use @grog68 script.

Flash ATV via command line from the creators GrogBuild FreeRange - Leading the way to simplicity

Flash VIX via command line from the creators GrogBuild FreeRange - Leading the way to simplicity

Thanks for your reply
Would it be just a case of connecting an Ethernet cable and following that thread?

 

[Willo3092]

Yes, you will have to flash ATV because ViX is not supported on the H2H.