Zgemma H2H "cannot read data" error

kendog

Newbie
im trying to setup a test line on my Zgemma H2H with WooshBuild. i was sent a Cccam and a newcamd file. i have tried going through the install with both, but when i do autoBouquetsMaker and scan, it will not bring back any channels and i get the error "cannot read data". anyone any thoughts on what the problem mite be?? thanks.
 
got it to pick up channels. i was using 00021 for Belfast but changed it to Derry 00027 and it worked. still not getting any picture on channels though..
 
Thanks for the help everyone. I change the I'd and did rescan. It wasn't showing any channels at first but when I manually typed in 101 it seemed to pick them up. Just need to install cam now. Thanks again..
 
Thanks for the help everyone. I change the I'd and did rescan. It wasn't showing any channels at first but when I manually typed in 101 it seemed to pick them up. Just need to install cam now. Thanks again..


you sure netid is correct Belfast 00021 Derry 00023 you must have correct netid.
 
Back
Top