Zgemma H9T

adamspaul97

Registered
Hi I've had one about 9months now and they are excellent must faster than other zgemma boxes inc my old h2h which I use as a second box upstairs
 

biff2005

TK Veteran
The H9 receivers have only 256MB of internal flash memory.
Specification:

  • ARMprocessorwith1500MHz Quad-coreCPU
  • OneDVB-T2/CHybrid tunerbuilt-in
  • Support4K-2160p
  • 256MB NAND Flash / 1GB DDR3 Memory
  • Picture inPicture(PIP)
  • 1xUSB3.0and1xUSB2.0
  • 1xHDMI2.0
  • 1x3.5mm AV
  • Externalpowersupply12V1A
 

jwjc

Registered
hi can anyone help I am strugging to install mgcamd 1.35a on my h9t box I have tried going to default skin but still nothing
 

jwjc

Registered

jwjc

Registered
hi there
still struggling it wont install 2.3.2 its saying syntax error near un expected token
 

BeakyFord

TK Veteran
your H9 is an ARM system so the standard cams on ATV are cccam or oscam, PurE2 can run MG 1.35 but its a new OS in development & is still in its testing phase. The easiest option IF you're not into making images & still want to use MGcmd would be to go with Willobuild as advised above (VIX)
 

pabloescaban

VIP Member
Forum Supporter
hi there
still struggling it wont install 2.3.2 its saying syntax error near un expected token
Which softcams are already installed?
go to softcam panel, click on the active cam (make sure the other is set to 'no cam') and click left/right, list here the softcams that are already on the box, there will be a few
 

jwjc

Registered
Which softcams are already installed?
go to softcam panel, click on the active cam (make sure the other is set to 'no cam') and click left/right, list here the softcams that are already on the box, there will be a few
I can only find softcam manager when I open it theres nothing in it
 

pabloescaban

VIP Member
Forum Supporter
this is because you have no softcams installed...from a blank screen:
press green
press green again
choose softcams
install oscam softcams and also CCcam2.3.2

this will create a softcam panel for you to play with
 
Top