Octagon SF8008 Initial Setup

Thanks - kegnkiwi. I have read this morning. All a little mind boggling at the moment. As I need to learn to how to open the OSCam Web Interface
Go to webiterface of your Octagon, do this by entering the IP of it in your browser

When your in the boxes web interface you should see a option down the left hand side Oscam interface. Click on that.
 
Go to webiterface of your Octagon, do this by entering the IP of it in your browser

When your in the boxes web interface you should see a option down the left hand side Oscam interface. Click on that.
thanks very much , will attempt tonight.
 
Go to webiterface of your Octagon, do this by entering the IP of it in your browser

When your in the boxes web interface you should see a option down the left hand side Oscam interface. Click on that.
How do I disable the to disable all readers except for the EMU reader?
 
If you go into the webif again and select files top the tabs at the top right of the page and then choose oscam.server then open the page. Each reader is in there. Each reader has a line that says enable. Set each one to 0 to disable it.
File does not exist or no file selected! Iv not setup correctly?
 
So you have no other lines running on that ?

You dont disable the EMU reader.
Hi Ferret , thats correct. The box was new of yesterday and I have no intention of using other lines as will be for feeds only. I have moved a softcam file into the box via file zilla and selected oscam and oscma emu from plugin menus. thats all I have done so far.
 
Getting somewhere but still no picture. Not doing something correct.

Please see snippets below of the key I've entered and the snippet of oscam script.

When i go into start the oscam emu and oscam later under softcam manger it says no config files found.
1699621921149.png1699622011002.png1699621970239.png
 
And how did you get it to work and clear 4:2:2? are you sure its 4:2:2.

Can you say what feed you are using and the details?
 
Back
Top