hi
if its twin tuners you got
the tuners must be set up wrong
do you have your 2 sat tuners connected to 28.2 as it needs a free tuner to run scan.
First make sure ur feeds are in top lnb and bottom right, as u look at the back. The loop under the top one should be empty.
Menu
setup
service searching
tuner config. Make sure both say 28.2e
If those dont work check the ends of ur feed cables by taking off metal ends and making sure outer wire/foil arent touching inner copper core.
meaning you have 2 sat cables connected and working,can you view another channel while recording another if not tuner not working and will need checking.
Another reason for this problem is after changing the configuration of tuner B you don't do a fresh channel scan you'll have this error. You just need to redo the channel scan, (ie Tuner B has been enabled when previously disabled ) otherwise ABM will just timeout...
Another reason for this problem is after changing the configuration of tuner B if you don't do a fresh channel scan you'll have this error. You just need to redo the channel scan, (ie Tuner B has been enabled when previously disabled ) otherwise ABM will just timeout...
you lost me on that also lol,even on solo2 or duo when tuners setup i just rerun abm and i would be using 1.38 for multi tuner boxes if running nlines.
Did you check your satellite lines are both working OK as mentioned in an earlier post?
Another reason for this problem is after changing the configuration of tuner B if you don't do a fresh channel scan you'll have this error. You just need to redo the channel scan, (ie Tuner B has been enabled when previously disabled ) otherwise ABM will just timeout...
ie Menu,Setup,Service Searching, Automatic Scan before running ABM and in ABM make sure previous bouquets are deleted - perhaps this is just an ATV thing but OP didn't state what image is in use...
Alright mate, why would 1.38 be better for a twin tuner running an nline?
over on wos they advise using 1.38 on their boxes and many are only on fixed dish.the makers of the cams know about the bugs and suggested to change to 1.38 or 2.3.0 if having issues.