yes, unless your box is a 4k box as mgcamd 1.45 is not available for arm based boxesAre these mgcamd 1.45 in the grog build?
If you press the green button and then the red button and then select softcams, what version of mgcamd is listed?i am also having problem cant get mgcamd 1.45. reflashed the box togrogbuild free range knowing might get the mgcamd i need but all in vail. dont quite know what you mean by arm box. using h2h box.
if you then selected mgcamd then it would have uninstalled it. go to downloadable plugins and you should be able to install it againsome how when i go to softcam manager its not showing mgcamd. dont know what i did but its not there when i do the above. do you think i have deleted.
yes if its a 4k box then you must use oscam for cable now as mgcamd 1.45 is not available for your boxhi folks ..mutant hd51 4k is it only oscam will work on this ..as mgcamd 1.45 is this correct ..been searching tae no avail ..thanks in advance
this is a friends gadjet ...yes mines in running ...He said he had mg1.45 running ok the day after the channels went off?
thanks..yes if its a 4k box then you must use oscam for cable now as mgcamd 1.45 is not available for your box
Put it in like thisthanks..
using your build just do the emu is this correct
[reader] label = VM_LINE enable = 1 protocol = newcamd device = URL,PORT key = 0102030405060708091011121314 user = USERNAME password = PASSWORD connectoninit = 1 caid = 1841 group = 1 emmcache = 1,3,2 blockemm-unknown = 1
change user port url 179.and so forth
you must have the following two lines in therethanks..
using your build just do the emu is this correct
[reader] label = VM_LINE enable = 1 protocol = newcamd device = URL,PORT key = 0102030405060708091011121314 user = USERNAME password = PASSWORD connectoninit = 1 caid = 1841 group = 1 emmcache = 1,3,2 blockemm-unknown = 1
change user port url 179.and so forth
thanks spot on straight onyou must have the following two lines in there
dropbadcws = 1
disablecrccws = 1