MGcamd stops when box put in standy

[lmicbry]

My VU+ Duo is working great with CCcam 2.1.4 & MGcamd 1.35. However, if I put the box in standby, the MGcamd stops working and I have to restart in softcam menu. Anyone got any ideas why this is happening. CCcam works fine

 

[mike123]

this can happen if you have not setup mgcamm coreectly.
if you are using a nline you are best to have only mgcamm running
if you are using c-lines just use Cccam
make sure you have enable on startup ticked and you should have no problems.
using the correct protcol will make the lines run the best they can.

read my post here
http://www.techkings.org/vu-solo-so...-camm-vix-image-vu-solo-vix-using-n-line.html

 

[lmicbry]

Cheers mike123
I am using both as I have a card which cccam reads and i have an N line whicg mgcamd uses as I find the n line on cccam to be less stable

 

[mike123]

try this mg config file

try this but keep a copy of your old one safe see if this helps put it in var/keys

 

[lmicbry]

no joy with that config file. cheers anyway mike. Will have a look to compare files anyway. cam must be stopped when in standby and does not restart when taken out of standby. means I cant record if box is in standby. bit of a pain. has to be some kind of fix out there for this

 

[mike123]

doe not look like it has been downloaded.

 

[lmicbry]

downloaded it fine, not much different than my own cfg file. but does not help the issue.
Thanks

 

[mike123]

are you using blackhole or vix on your duo. use the 1.38 above working flawless on vix image. also if you downloaded from ts panel you will have problems