multiple lines

[afterburn]

can you have more than one nline in mgcamd on enigma 2 vix image? Can you put an nline into CCcam?

 

[mike123]

you can do. however, with a good server you should ot need to and yes you can put a n-line into CCCAM.

 

[afterburn]

you can do. however, with a good server you should ot need to and yes you can put a n-line into CCCAM.

I know I'd just like the 2nd as back up. How would I go about putting an Nline in cccam in the vix image? Do i just change the start of the line to "C: myline etc" and disregard the des key at the end?

 

[waldo176]

take the newcamd file and open it up copy it over to a cccam.cfg file and change the cws = to N:

so file would look like N: host port user password 01 02 03 04 05 06 07 08 09 10 11 12 13 14

 

[bees]

I have just switched two N lines from CCcam and i'm
running them in MG Cam, they seem to run better.

One for cable and one for sat.

You could always try this too

Open or make a completely blank newcamd.list file,
paste into the file both lines, directly underneath each other, ftp to box.

As mentioned above your n line will start "CWS = " in Mg Cam
and "N : " in CCcam

 

[paulsysp]

Im with bees here i have sky and cable line in mgcamd.. Just incase one fails ;) both work great.

 

[afterburn]

Im with bees here i have sky and cable line in mgcamd.. Just incase one fails ;) both work great.

Personally i have never seen any difference between having the line In CCcam or MGcamd. MGcamd needs to be restarted at Boot up since I upgraded the image which is a bit of a nuisance.