carmine
Member
Hi Guys,
I have owned my Zgemma for over 4 years now it was all working well for what i needed it for until the last 4/5 months on and off a but problem has steadily worse.
I have motorised system that turns from 30 west to 42 east.
Problem is that it gets stucks on any satellite position and only way to get in working is with remote go to menu / set up / tuner & scannings / Signal Finder and then move with remote to 0.8 west and by changing frequencies or going with left arrow or right arrow to other sat positions and back to 0.8 west it locks onto 0.8 west with Green Lock and its working again,
This fix use to last a couple of days but now im finding that i have to do at least a couple of times a day if im in all day watching TV very annoying.
As of now am stuck again on Signal Finder page but 0%AGC or BER and dB....
I try and tune in on signal finder page different frequencies but with no luck although this use to work straight away before ???
All very confusing.
About 1 year to 18 months ago ran whole new run of Satellite Cable all new f connectors and new lnb and motor so im guessing its problem with the box itself, has anyone else had this problem and if so is there an easy fix or is it a case that i may need a new box ???
as im posting this its now locked in again on frequency 10841H 25000 3/4 not that i can see these channels but system back up working as it should as i said all very strange Please advise any advice most welcome
Regards
Carmine
Im running Openpli 7.3-release
I have owned my Zgemma for over 4 years now it was all working well for what i needed it for until the last 4/5 months on and off a but problem has steadily worse.
I have motorised system that turns from 30 west to 42 east.
Problem is that it gets stucks on any satellite position and only way to get in working is with remote go to menu / set up / tuner & scannings / Signal Finder and then move with remote to 0.8 west and by changing frequencies or going with left arrow or right arrow to other sat positions and back to 0.8 west it locks onto 0.8 west with Green Lock and its working again,
This fix use to last a couple of days but now im finding that i have to do at least a couple of times a day if im in all day watching TV very annoying.
As of now am stuck again on Signal Finder page but 0%AGC or BER and dB....
I try and tune in on signal finder page different frequencies but with no luck although this use to work straight away before ???
All very confusing.
About 1 year to 18 months ago ran whole new run of Satellite Cable all new f connectors and new lnb and motor so im guessing its problem with the box itself, has anyone else had this problem and if so is there an easy fix or is it a case that i may need a new box ???
as im posting this its now locked in again on frequency 10841H 25000 3/4 not that i can see these channels but system back up working as it should as i said all very strange Please advise any advice most welcome
Regards
Carmine
Im running Openpli 7.3-release