I still have not put up the dish having second thoughts due to the size 97cm all others near me are the small oval sky dishes.How did you get on @urie ?
Im looking at putting a dish back up too. Not sure if there any advantages to a motor rather than just using freesat. I have IPTV anyway so this is purely just a backup.
Most bricklayers these days seem they have used a catapult to lay bricks and need a new bubble for there levelWith the starter kit it likely is a 90° 36cm
50cm L bracket Instead of T.k set Complete
Different methods of installation If you are
Fitting L bracket to brick wall The wall.will
Not be level running down Its easy enough
Getting the bracket 90° left to right The problem is getting the bracket level to the
Front You might be better using 10mm plugs 13mm coach screws to give better
adjustments If you run the spirit level down
The wall you will see how much the bracket
Will need built out to get it level to the Front
What I would do get the bracket 90° left to right A digital leveler is a good Investment
Then put the leveler on the front of the bracket before you tighten the bottom coach screws dill another hole plug coach
Screw washer Just below the middle of the
Bracket at the bottom Then tighten the coach Screw and fit the washer underneath
The bracket Then fit washers either side
Tighten the bracket up Until it is 90 ° to the
Front and side
Actually, if you purchase from wos the first drop-down box is what firmware do you want installing. So for a £1 then will put on it any image you wish. Its really down to choice. Lots of people like openvix images. I personally don't like those images and like either openatv or pure2. My image of choice is pure2 at the moment. Below is a screen grab of what it looks likeThanks kegnkiwi. Id want it set up just with a single satellite input. Good to know that the receiver can accept the genuine cams and cards if needed. Assume that when i buy it new from world of sat the softcams, and extra bits that need to be installed to allow eurolines will not be present...Have to look on this site and find a pre built build to put onto it?
Thamks.
They do thats why I mention a vix image to start with.If I remember correctly VIX does have sofcams in Plugins where as openATV does not you need to install from softcan feed.