Hi all,
I have got a a780, flashed it recently to 19012015 using loader and usb-serial adabpter, factory reset and rescanned (as suggested in all the tuts), seem to be able to see BEEB1 so I know the cable feed is OK, but when I scan for updates, it just sits at scanning, never finds anything, also no 'other' channels are clearing, just scrambled.
Anyone else in the Nottinghamshire area having these kinds of issues?
Thanks.
Regards
Flea
**edit** just noticed there is a 20012015 firmware release, I will try that, see if that helps. Will respond shortly.
---------- Post Merged at 03:29 PM ----------
Okes updated to this now, factory reset, and rescanned :-
Date : 20/01/2015
Software Version : Kryptview A780 pv4.2.08
H/W version : v3.0.0
All channels found, still wont descramble. :/
Autoupdate just shows searching for new update
Regards
Flea
I have got a a780, flashed it recently to 19012015 using loader and usb-serial adabpter, factory reset and rescanned (as suggested in all the tuts), seem to be able to see BEEB1 so I know the cable feed is OK, but when I scan for updates, it just sits at scanning, never finds anything, also no 'other' channels are clearing, just scrambled.
Anyone else in the Nottinghamshire area having these kinds of issues?
Thanks.
Regards
Flea
**edit** just noticed there is a 20012015 firmware release, I will try that, see if that helps. Will respond shortly.
---------- Post Merged at 03:29 PM ----------
Okes updated to this now, factory reset, and rescanned :-
Date : 20/01/2015
Software Version : Kryptview A780 pv4.2.08
H/W version : v3.0.0
All channels found, still wont descramble. :/
Autoupdate just shows searching for new update
Regards
Flea
Last edited: