Hello all,
I upgraded from $ly f5s to zgemma h1 (mainly for getting all channels in hd)
Anyway I flashed the h1 with sucmnsee new firmware Followed all the instructions correctly.
The satellite (TunerA) works perfectly fine along side the EPG. No problems with that.
However I'm struggling with the cable side of things (TunerB)
I've searched the forum and tried all sorts of things.
My area code is in fine (00005)
Because cable is downstairs & Sat is upstairs I switch between the 2.
When I do an Automatic search on the cable tuner it picks up all the channels which is good.
But as soon as I go onto autobouquetsmaker and try a scan it comes back with No nims found.
I already disabled tuner A when I do this scan.
Completely puzzled on why it wont scan on autobouquetsmaker.
The newcamd.list is set up:
Line 1: VM line
Line 2: Sat Line
I'm using MGcam 1.38
Any other info I need to provide let me know.
Thanks for reading
I upgraded from $ly f5s to zgemma h1 (mainly for getting all channels in hd)
Anyway I flashed the h1 with sucmnsee new firmware Followed all the instructions correctly.
The satellite (TunerA) works perfectly fine along side the EPG. No problems with that.
However I'm struggling with the cable side of things (TunerB)
I've searched the forum and tried all sorts of things.
My area code is in fine (00005)
Because cable is downstairs & Sat is upstairs I switch between the 2.
When I do an Automatic search on the cable tuner it picks up all the channels which is good.
But as soon as I go onto autobouquetsmaker and try a scan it comes back with No nims found.
I already disabled tuner A when I do this scan.
Completely puzzled on why it wont scan on autobouquetsmaker.
The newcamd.list is set up:
Line 1: VM line
Line 2: Sat Line
I'm using MGcam 1.38
Any other info I need to provide let me know.
Thanks for reading