Hi, Any tips appreciated .. was up 5 hours last night reading through guides.
Setup
- Zgemma H2H
- Currently using Sucmnsee image (tried biohead same issue)
- VM Cable only - No Sly feed
Trying to scan VM for channels however 0 found. (finding freeview ok when switching to DVB-T2 tuner)
To help troubleshoot ...
-- Q1 .Can anyone confirm if a line is required just to find VM channels when doing a scan (obv would expect them to be encypted so not view)?
-- Q2 .Is there a way I can search all channels?
-- Q3 .I am pretty sure my NetID is correct but not 100% .. would I get no channels if it was incorrect?
-- Q4 .Running autobouquets also fails - tuner lock timeout .. however again I believe these are not required to find channels?
-- Q5 .Is there a way to check the signal strength before scanning for channels?
Steps taken
- disable tuner A, configured Tuber B
- Cable in RF port with adapter.
- configured tuner B, as per guides .. net ID, virgin UK etc -- I even tried some of the brute force scans.
- Tried adding both c/n lines .. however I assume not required just to find channels?
Apologies for another thread, but none of my searches have solved my issue.
Thanks
Setup
- Zgemma H2H
- Currently using Sucmnsee image (tried biohead same issue)
- VM Cable only - No Sly feed
Trying to scan VM for channels however 0 found. (finding freeview ok when switching to DVB-T2 tuner)
To help troubleshoot ...
-- Q1 .Can anyone confirm if a line is required just to find VM channels when doing a scan (obv would expect them to be encypted so not view)?
-- Q2 .Is there a way I can search all channels?
-- Q3 .I am pretty sure my NetID is correct but not 100% .. would I get no channels if it was incorrect?
-- Q4 .Running autobouquets also fails - tuner lock timeout .. however again I believe these are not required to find channels?
-- Q5 .Is there a way to check the signal strength before scanning for channels?
Steps taken
- disable tuner A, configured Tuber B
- Cable in RF port with adapter.
- configured tuner B, as per guides .. net ID, virgin UK etc -- I even tried some of the brute force scans.
- Tried adding both c/n lines .. however I assume not required just to find channels?
Apologies for another thread, but none of my searches have solved my issue.
Thanks
Last edited: