What's new
By:
Filters

VU+Duo / Wooshbuild

pabloescaban said:
If you have atv 6.3 you just add infinity now by using webif/Terminal
Paste command line in and away you go
Click to expand...
Thx again Guys! I can only find MAC address for this box in order to use above route for Wooshbuild infinity now that I have loaded OenATV 6.3 successfully. Where do I find IP address for his box pl.? One more push Pals. O
 
Or open command and prompt on your laptop and type ping vuduo
This will give you the ip address of your box
 
Sorry about all the stops and starts Guys. Got the IP address, managed to get as far as Open Webif page but down on the left in Extras, there is no "Terminal" option. Although following options are there. Box is connected to the internet. Where else can I find the "Terminal" option . Any help pl
 
Thank you so much to everone who contributed to this thread. Did manage to install Wooshbuild in the end.. Fantastic amount of help.
 
atiq1 said:
Thank you so much to everone who contributed to this thread. Did manage to install Wooshbuild in the end.. Fantastic amount of help.
Click to expand...
Must share my experience Guys! Using Putty route, I tried to install Wooshbuild infinity, using the right command. It installed that alright but when I ran it, I could see Wooshbuild Infinity screen and while going through the Menu options, it encountered software problem and it closed down and restatrted facing the same problem at the same stage like last time.
So taking it into account the opinion of respected wise guys here, I decided to use Grogbuild and it went fine but when the box stated again, it didnt have any logo in the background like Wooshbuild . It is giving me Open ATV logo and Menu. As it is not official Wooshbuild Infinity method, How can I check if Grogbuild method has been sucessful and installed? Thx
 
Did you paste the grogbuild command line in webif/Terminal?
It asks you if you use cable and asks for your netid etc and a few other questions then flashes atv and puts grogbuild on
 
Yes I did everything as required. But like wooshbuild infinty logo should there be a grogbuild logo in the background?
 
How are you doing it?
You initialise the usb in the box.
Then paste grogbuild freerange command line in terminal and answer 5 or 6 questions and it does everything itself
 
pabloescaban said:
How are you doing it?
You initialise the usb in the box.
Then paste grogbuild freerange command line in terminal and answer 5 or 6 questions and it does everything itself
Click to expand...
Pablo! I repeated the process once again thoroughly, the box rebooted without any problem with the same results but then reading Grog's loading instructions for GBFR, these lines caught my eye:-

"As we do not use an image in Grogbuild FreeRange it will install in just minutes on any Engima2 set top box that has openATV installed."
so would it be fair to assume that there won't be any monkey logo in the background for GBFR. please correct me if i am wrong.
 
You must log in or register to reply here.
Back
Top