What little hair I had is gone, I suspect it is something simple, but I'm jiggered if I can see it and I am a bit cross-eyed at the minute.
If I scan for channels using ABM, I get this error:-
So, I go to Settings/SetUp/Service searching/Tuner config and see all three tuners are active:-
I then go into Tuner B and these are my settings:-
Then Tuner C and the Settings are:-
I then exit out and go into Providers, This is what I get:-
As a trial, I disabled tuner C, and the error message changed to "Failed to tune on tuner B".
I have all my channels, I just can't run ABM to update any channels that may have changed on cable or satellite.
I have flashed with the latest Wooshbuild 7 earlier to see if that would overwrite whatever was wrong, and upon trying to set up, I get the same errors.
They all look correct to me, can anyone help?
If I scan for channels using ABM, I get this error:-
So, I go to Settings/SetUp/Service searching/Tuner config and see all three tuners are active:-
I then go into Tuner B and these are my settings:-
Then Tuner C and the Settings are:-
I then exit out and go into Providers, This is what I get:-
As a trial, I disabled tuner C, and the error message changed to "Failed to tune on tuner B".
I have all my channels, I just can't run ABM to update any channels that may have changed on cable or satellite.
I have flashed with the latest Wooshbuild 7 earlier to see if that would overwrite whatever was wrong, and upon trying to set up, I get the same errors.
They all look correct to me, can anyone help?