cannot get any satellite signal on wooshbuild infinity

[gorge]

hello
i have wooshbuild infinity image installed but cannot get any signal for hotbird satellite , i use to get full signal with other receiver , any help thanks

 

[grog68]

can I suggest you only start one thread with your question rather than starting 2 threads about the same thing as mods don't like it and some will think you're spamming and ignore your posts.

Unfortunatley I can't answer your question but hopefully someone in the know will.

 

[linesman66]

It's nothing to do with wooshbuild
Its only your image
What why have your tunners configured
Are you using multisat system with
DISEQC switches
Have you two different satellites
To each tunner

 

[gorge]

juno only one satellite with 1 lnb
i use to get hotbird with full 100% signal on other receiver but this h2s no channel at all no signal some times only get 20% signal and then gone

 

[linesman66]

It has been bad weather of late Is your sattelite dish out off alignment
Try your other stb to confirm its not your
Tunner but signal problem

 

[moshibeth]

Check you have the cable in thecorrect connection on the box. Lnb not loop

 

[gorge]

thanks yes the cable in lnb not loop and still cant get any channel

 

[grahamer67]

Is this after a re flash that your signal has gone?

 

[steptoe]

Have you set up the tuners correctly on the box,?

 

[spider1965]

Had one like this a while ago and it was the power supply even though it booted fine it would not show channels ,try another if you have one