hi got my box and installed ipab 1.3.5, but
went through the guide and did the following:-
1) disabled sat, setup tuner to correct netid, provider scan vm for my area, then setup provider for boquet for my area, scanned and it failed after about three seconds.
2) then as someone else suggested configured tuner and left netid to 00000 tried again failed
3) then tried bruteforce on symbol 6952(symbol for area) failed again.
checked cable by removing isolator(will that make a difference on signal?) from wall socket and directly attached 2 ways splitter i got when i got new s hub3.
same problem.
any ideas, thanks in advance.
went through the guide and did the following:-
1) disabled sat, setup tuner to correct netid, provider scan vm for my area, then setup provider for boquet for my area, scanned and it failed after about three seconds.
2) then as someone else suggested configured tuner and left netid to 00000 tried again failed
3) then tried bruteforce on symbol 6952(symbol for area) failed again.
checked cable by removing isolator(will that make a difference on signal?) from wall socket and directly attached 2 ways splitter i got when i got new s hub3.
same problem.
any ideas, thanks in advance.
