"I think"
Plug in hdd and mount it
Then go to rec/timeshift/epg paths and make sure theyre all set correctly. If all good reboot and check did mounts change at all or still ok.
Press yellow for location see if it's there"I think"
Plug in hdd and mount it
Then go to rec/timeshift/epg paths and make sure theyre all set correctly. If all good reboot and check did mounts change at all or still ok.
When using separate hard drives for recordings how do you access the recordings for playback?
I have set up a second hard drive and it is successfully recording, I can see the recordings via ftp but if I press file list on the remote control I only have access to the original USB drive and not the drive with recordings on.
Box off
Hdd out
Format on pc
Back in box
Box on
(Depending on T.S. settings do below quick)
Menu
Setup
System
Storage devices
Initialisation
Select ur drive
Red to initialise
Wait
Menu
Setup
Vix
Swapfile manager
Blue to create. 256mb
Wait
Yellow to autostart
Green to start
Red to exit
Hold power on remote and select restart
---------- Post Merged at 08:30 AM ----------
Check epg and record/timeshift paths are set correctly.
Try recording