Hi everyone! Not posted for ages! Sorry for the long post, and any mistakes as I am on mobile.
I've not used my zgemma for a few months, but decided to renew my IPTV sub. I was having issues getting any channels to work, so my supplier suggested updating my box (I was on Wooshbuild v5). I downloaded the latest, but couldn't get it to flash. I tried manually flashing through the menus on the box, but got an error about not having enough memory .
So I decided to factory reset my box .And this is where is all went wrong. After wiping the box, it started to boot again and shows the Wooshbuild logo. I would then get a blue screen saying there were errors and the box would reboot. When rebooting it started from 50%. It was stuck in this loop.
I switched the box off and this time inserted my usb into the back. Issue is due to the size of the stick I cannot have the hdmi cable in at the same time. However it did display flash on the screen, and after a few seconds this changed to boot . But then nothing...
I tried again and again with no success . I even downloaded the stock files from the zgemma website to no avail .
Is the box dead? Is there any hope of fixing this?!
I've not used my zgemma for a few months, but decided to renew my IPTV sub. I was having issues getting any channels to work, so my supplier suggested updating my box (I was on Wooshbuild v5). I downloaded the latest, but couldn't get it to flash. I tried manually flashing through the menus on the box, but got an error about not having enough memory .
So I decided to factory reset my box .And this is where is all went wrong. After wiping the box, it started to boot again and shows the Wooshbuild logo. I would then get a blue screen saying there were errors and the box would reboot. When rebooting it started from 50%. It was stuck in this loop.
I switched the box off and this time inserted my usb into the back. Issue is due to the size of the stick I cannot have the hdmi cable in at the same time. However it did display flash on the screen, and after a few seconds this changed to boot . But then nothing...
I tried again and again with no success . I even downloaded the stock files from the zgemma website to no avail .
Is the box dead? Is there any hope of fixing this?!