What's new
By:

Ibox 2 plus running openPLi c issues

G

gazhodge

Newbie
Hi all,

I'm having a few issues with my C: and getting to work on my ibox2 plus,

To start i can get my N: to run on the boc no problem at all by FTP the details over into the etc/cccam folder :p

the problem starts when i want to put my C: onto it, it just does nothing lol

I have put the details into etc/cccam folder = nothing and have put them into the usr/keys folder as instructed by my provider. i have also replaced the mg_cfg.dat file which was provided by him but still nothing :nolisten:

I have try different combinations with the softcam setup = CCcam/mgcamd but still nothing. I have also put mgcamd_1.38c on but for some reason when on this it keeps going back to CCCam once it saves.

I am running image OpenpLi 4.

Really can't see why the N: would work no issues and the the C: nothing


Anyone got any ideas?
 
Ok it seems a bit all over place. I dont know openpli so hope none of this sends u wrong.

1st off Cline should only be used in cccam and nline should be used in mgcamd. However nline will work in cccam.
2nd only one will run at a time. And mgcamd will not autostart with the CCcam.cfg file or cccam plugin installed. Can be started manually tho.
So maybe just straight swap what ur trying to do and put ur nline in mgcamd 1.35a and cline in cccam 2.1.3.
Again all this is how it works in Vix not openpli but I hope it helps.
 
Hi, thanks for getting back to me,

The Nline will only seem to work on the cccam setup and nothing on the mgcamd :anyonethere:

I have downloaded and mgcamd 1.35a but still get nothing :( Where when FTP the details to the box does the line details go for the mgcamd?

---------- Post Merged at 10:21 PM ----------

Right I have managed to get the c: working on CCCam but as for the mgcamd i have no idea :(

The only way i can get it to work is if i use N: instead of C: at the start on CCCcam to work :(

Just where to put the details really for mgcamd?
 
Last edited:
If ur trusting enough u can pm me ur full nline and ill send you the two files to put in /usr/keys.
but make sure u have mgcamd started, autostart on and reboot the box preferably by switch.

---------- Post Merged at 10:30 PM ----------

Or read through here by mike123 guide

http://www.techkings.org/vu-solo-support/57166-how-install-mgcamm-1-35a-vix-image.html

---------- Post Merged at 10:32 PM ----------

Again this is all Vix but I 'assume' cams are same for openpli
 
Hi which open pli image are you using is it the latest and if so can you confirm you can get crossepg to work as I'm having trouble getting this to work on the new open pli image and as to your question just use FileZilla and open etc, cccam file copy and paste and make sure and click copy and save and make sure it uploads to box hope this helps
 
You must log in or register to reply here.
Back
Top