What's new
By:

Moving dish message

A

Andyrew67

Newbie
I have just setup my openbox v5s and all appears to be working ok.
Channel list needs tidying up as there are a lot of duplicates and non working channels.
I have noticed a couple of things though.
It takes a good 30 second to boot up and when it does it says "moving dish"
It is connected to a normal static s*y dish so no idea there.
Also certain channels break up more than others.
Any help appreciated.
 
haha must have setup for usals and other sats box is confused,was channel list for more than 28.2?

dont worry others can guide you better,its all a learning curve m8.
 
Last edited:
I hope so coz I haven't a clue what you are taking about lol.
It has been configured to get all the scrambled channels so I don't want to lose that by fiddling around without knowing what I'm doing.
 
Try reading this first it may help.
View attachment 12706
Reaper.

---------- Post Merged at 09:30 AM ----------

Also go into menu---installation---sat list. Scroll thru sat list and ensure only 28.2e is ticked on the left of screen [untick all others if on a fixed dish]
Then edit all sats [diseqc/usals] on right hand of screen to read off. Now save and exit all, this should remove the moving dish message but on some firmware it stays but does nothing unless dish motorised.
Reaper.
 
Thanks for that! Will try that when I get home.
As always, very helpful advise. Love this forum for that!
 
Did as you suggested reaper and all OK now. Thanks for the help!
By the way does anyone know if the HD channels are back? Would have liked to have seen the match tonight in HD :-)
 
You must log in or register to reply here.
Back
Top