I'm looking to move the line to the box using dcc in newcamd format
If you wish you can put an n-line into CCcam.cfg, probably much easier as already setup. I've just tried an n-line both via mgcamd1.38 (using newcamd.list) and cia CCcam.cfg and it doesn't make any difference.....If anything the nline runs better in CCcam.cfg!!
I take it you have the IP of the box? And you can ftp to it (use filezilla or DCC)
Go to /usr/keys/
Create a file called there called CCcam.cfg in notepad (note it is case sensitive two capital C's then the lower case in the filename), in this file enter your line details - If your currently using newcamd replace the CWS = server with N:
eg:
N: server port username password 01 02 03 04 05 06 07 08 09 10 11 12 13 14
Save the file. Press Blue, Softcam, Softcam Panel and Green then exit out, you may need to restart your box.
If you really must use mgcamd......
Green, Red, Softcams, Uninstall CCcam 2.30 confirm and exit once done.
then.....
Green, Green, Softcams, Install newcamd 1.38
Then put your n-line details into a file called newcamd.list and copy this along with mg_cfg to /usr/keys/ using your ftp software.
(example newcamd.list and mg_cfg files have been made available in the downloads section by Sucmnsee)
Once your files have been ftp'd over to the box....
Blue,Softcam, Softcam Panel, press the right direction button until use see mgcamd displayed next to softcam1, then press green. You may need to reboot the box.