Hi All
I am trying to set up a friends Zgemma H7s with a motorised dish and from the offset I cannot get a signal on the H7s when I feed the cable through the motor.
I get no signal on the h7s even though dish is looking at 19 E ,
however I get 70% signal On my meter as well as TV pictures and sound on my meter, but when I reconnect the cable back to tunner 1 on h7s no signal again.
However If i by pass the motor and go straight from the lnb to tunner 1 or 2 on the zgemma h7s then i get a signal again, but if i run the cable through the motor i loose the signal on the box. But still have signal on the meter. Ive tried two different h7 boxes and both have same issue. Ive tried open atv 6.1 and 6.2 both raw with no builds and then both with wooshbuild . Still no joy. Cannot figure out why this is occuring. Tried different configurations. Ie tried simple setting usuals selecting satellites ect.
Ive tried advanced usuals 1 lnb65 ect no joy. Ive run brand new cable from dish to motor to receiver . No joy. I've fitted brand new f connectors , no joy Just about given up.
Im using a selfsat flat dish 50hd2.
It has two lnb outputs for two receivers but one lnb output doesnt work. But dont see why this should effect the signal especially seeing as if i bypass the meter i get a signal and going through the motor i still get signal picture and sound on my meter. My meter has usuals settings but is battery operated hence cant get motor to move with my little budget but effective meter. Im using a selfsat hh90 motor made for the square flat dish . Just like any other motor apart from no lights. Small and designed for this particular dish. Any help much appreciated