Hi Guys,
I have a blade 7000 HD which was working on thursday and then suddenly started showing blinking red light.
I have found another post here on this site which advised to get the box into engineer mode and reflash the firmware but my trouble is that it never gets into engineer mode. Can someone help?
Here is what I have done.
1. Connect the box to TV via HDMI.
2. Remove Ethernet and Coax.
3. Replace a new USB disk / formatted old disk with latest firmware plugged at the back.
4. With the box off - press and hold the center button upwards [this is where it says menu]. I have also tried to press this whole button.
I tried holding them for a few minutes but nothing ever came up on TV. Can someone pleasseeeeee helpp as I am a desperate noob.
I have a blade 7000 HD which was working on thursday and then suddenly started showing blinking red light.
I have found another post here on this site which advised to get the box into engineer mode and reflash the firmware but my trouble is that it never gets into engineer mode. Can someone help?
Here is what I have done.
1. Connect the box to TV via HDMI.
2. Remove Ethernet and Coax.
3. Replace a new USB disk / formatted old disk with latest firmware plugged at the back.
4. With the box off - press and hold the center button upwards [this is where it says menu]. I have also tried to press this whole button.
I tried holding them for a few minutes but nothing ever came up on TV. Can someone pleasseeeeee helpp as I am a desperate noob.