What's new
By:
Filters

ET8500 QUAD TUNER Power issue on tm2600 motor

weimaraner95

weimaraner95

Member
Hi,

Put my 1m dish and motor back up
After connecting cables I don't get green power on the motor, if I connect my VU duo I get power,
Any ideas what it can be , I had to re do the f connection.

Could it be the cabling
 
weimaraner95 said:
Hi,

Put my 1m dish and motor back up
After connecting cables I don't get green power on the motor, if I connect my VU duo I get power,
Any ideas what it can be , I had to re do the f connection.

Could it be the cabling
Click to expand...
So does it work with the duo connected?
Not sure what you are asking.
 
Sorry could have worded that better

Initially had no power on both boxes , recut the cabling and fitted f connectors.
Vu Duo power
Xtrend no power
 
Last edited:
LNB both setup the same on both boxes ?

Usuals setting the same on both boxes ?
 
Most people ask about tuner config. They never describe wiring, number of tuners, number of ports on LNB etc. The two have to match each other.

How many satellite tuners on receiver?
How many signal wires from receiver gong to dish?
If more than one signal wire, are they easily identifiable?
How many ports on LNB of motorised LNB?
 
Vu Duo tuner A with usuals and single tm-1 universal Lnb.
Tuner B disabled

Xtrend 8500 quad only configured 1 tuner with same usuals and lnb

Both boxes running openvix
 
Have been back up and I have no power on the motor now with the Vu Duo, and sorry it was actually a TM 2300. May be it was on its way out
 
You must log in or register to reply here.
Back
Top